Much help needed, please

[RidiculousOrange]

Ok, I ordered a Xecuter 2.6 CE chip and it came today. My friend came over so we could install it in his v1.0 xbox.

We did the wire install, double checked it, and put it all back together. Booted it up and got the FlashBIOS 3.0.3 screen. I installed my harddrive from my xbox (already modded) so i could just do a flash from hard drive. It went through the motions, had the loading bar and shut off when it was done. But i booted back up and it had the FlashBIOS still. I tried it again with no difference. I switched over to the Network Flash option and still no change.

So I took the mod out, used the motherboard from my parts xbox (tested WORKING, also a v1.0), put the mod in there and tried it again. And I got the SAME problem.

And now I can't boot from Bank1 anymore, it tries to boot 3 times then FRAGs.

I'm no n00b to electronics either, I'm going to nationals for an Electronics Technology competition next month, but I don't know what else to do with this.

PLEASE help me out with this,
Orange

 

[RidiculousOrange]

UPDATE: Ok, I tried to flash it with Evox 2.6 v1.0 and it FRAGged on Bank1, so I put it on Bank2 and flashed it with x2_4975_256k and it took it.

One problem, that DOWNGRADED it, so now on Bank1 i have FlashBIOS 3.0.1 and on Bank2 I have FlashBIOS 3.0.3. So now i know the chip CAN be flashed, but WHY CAN'T I PUT EVOX ON IT.

Please guys I really need some help,
Orange

 

[DJBOOBY]

x2 5035 v1.0 to v1.5
x2 5035 v16 plus v1.6 1.6b xboxs

 

[RidiculousOrange]

ok where are those on Xbins, i can't find them

 

[Gdubb]

hey there ban buddy

http://www.consolerealm.com/

just register and you can download the new Biosessss