FIXED MXIC help please?

[Paddy1234]

ok I just tried MXIC this board and its not having it I done 2 cuts did 1 first never worked and then 2nd didn't either here is a pic.







Ive done 1 before and a few winbonds but I prefer doing the winbond as its just a straight drill. Am I able to do it to this board as it works fine just isnt having it Unless someone knows what to do ? Have I gotta Solder my two traces back up and go bit deeper and try a new cut?

Thanks

Pat

 

[Martin C]

Have you checked the cut with a meter?

Where's your JF log?

 

[Paddy1234]

Have you checked the cut with a meter?

Where's your JF log?

Serial flash found with Status 0x72


Sending Device ID request to port 0x0000
Spi Status: 0x8C
Manufacturer ID: 0xC2
Device ID: 0x11
Flash Name: MXIC(MX25L2005)
Flash Size: 262144 bytes


Sending Spi UnLock request to Port 0x0000
.....................................................................................................................................................................................................................................................................................................................................

No I havn't Mate

 

[BL4K3Y]

What are you doing after sending the unlock command?

Are you using a probe?

You really can't do much more until you confirm that the trace was cut properly.

 

[Paddy1234]

What are you doing after sending the unlock command?

Are you using a probe?

You really can't do much more until you confirm that the trace was cut properly.

Yeh mate I am but there are a few cuts now So should I solder all of them Up and do another 1?

 

[BL4K3Y]

Yeh mate I am but there are a few cuts now So should I solder all of them Up and do another 1?

A few cuts?

Solder it back together and confirm that the drive still works in your console before trying again.

 

[Martin C]

Because soldering them to do other cuts is going to help you.....why?

You understand you're cutting a trace to stop connectivity, yes?

Post a pic of your Sputnik probe as well as your full JF log.

 

[Paddy1234]

Because soldering them to do other cuts is going to help you.....why?

You understand you're cutting a trace to stop connectivity, yes?

Post a pic of your Sputnik probe as well as your full JF log.

JF log

Serial flash found with Status 0x72


Sending Device ID request to port 0x0000
Spi Status: 0x8C
Manufacturer ID: 0xC2
Device ID: 0x11
Flash Name: MXIC(MX25L2005)
Flash Size: 262144 bytes


Sending Spi UnLock request to Port 0x0000
.....................................................................................................................................................................................................................................................................................................................................

Its also If i try probe it it like gets real Hot on the probe On my hand If u get me like burns me a little sorta thing.

 

[ball00]

Surely quicker to use your multimeter to test connectivity than asking here?


Spelling errors come thanks to Tapatalk HD

 

[Martin C]

It would take you 2 seconds to check the cut - I would do it before you damage something.

In fact you should have done it before even trying.

 

[Paddy1234]

It would take you 2 seconds to check the cut - I would do it before you damage something.

In fact you should have done it before even trying.

Done! Thanks for help Guys It was My cutting I didn't push it Hard enough and must of not gone deep enough to cut it All unlocked now.

 

[Martin C]

I think lesson learned. ALWAYS use a meter to check the trace is cut before burning something out.