I think my console is being a d**k so i will just wait for the cr4 because they said it insta booted on stubborn consoles. So Yeah
RGH My corona v4 wont glitch. eeeccccccchhhhhhhhhhh
- Thread starter brent1wer
- Start date
Oh i didnt see that. Btw im sorry for all the tdo miss matches i kept looking for coolrunner but i got it pastebin.com/ep42MTrd
No its not winbond. If it was i would of lost all hope. Its just the plain samsung ram
Last edited:
gazcoigne
BANNED
RayBray
VIP Member
Please post the photos of your connections to the conceal.
i just like to say you need to work on your soldering skills, cold joints tend to be one of the most common boot problems and times.
also did you check your post fix adapter before soldering it in.
i just like to say you need to work on your soldering skills, cold joints tend to be one of the most common boot problems and times.
also did you check your post fix adapter before soldering it in.
I have it connected to the main cpu rst under the x-clamp. But ill try that and yea im sorry for the cold solder joints. I use a good amount of flux and it still does that. Its just the type of solder i got this time. The cable doesnt look like its on but its firm i was afraid of retrying because people easly lifted the pad. http://imgur.com/UOOXLwP
RayBray
VIP Member
Ok looking at the photo. it looks like there is a bridged connection that could be the problem.
Also please post your log and photos of the NAND points, To see if there is any other points that are soldered.
Also please post your log and photos of the NAND points, To see if there is any other points that are soldered.
nofeloniesyet
VIP Member
probably dont help ur using a method known to work on trinity consoles,and not corona.use short as possible wire to ft3t10 on bottom,and c5r11 dont matter if it gets pulled on corona,its a dead end on that board,only needs repair if pulled on trinity.ofc this dont mean go pull it up on purpose,just stating it dont need repair if it happens to happen.
Last edited:
Ok. Well if you guys dont know could you at least point me to where i can ask about xbox 360 phat problems so i can at least glitch my phat
Antalpromille
VIP Member
it look lika a solder bridge on the last two points to the right, upper row. measure them and make sure they have no connection.
Ill fix that but i have a random question. It still boots stock so would that have an effect on the glitch chip?
Ok thanks everyone for the help. I got it to glitch and it instaboots. Gazcoine was helpful for that point. I used that and it worked but i cant put the case on or it wont try to even glitch. My console is a mule