LITEON 93450 My new firmware is not verfied by JF

[hercules_1010]

I have a Lite-on DG-16D2S with firmware 93450C the drive did have ixtreme LT+ v1.1. I needed to update my dashboard to be able to run new games so i returned the drive to stock firmware as in JF tutorial then updated the dashboard to the latest and every thing was going great and now my drive firmware is 02510C. I finally have to put the new ixtreme LT+ v2.0 to my drive i used the JF tutorial again, in the first time i was flashing the drive on the same pc that it was previously flashed on during v1.1 so the drive was verified but now my drive with the new firmware isn't verfied by JF so i need to know:
1.I have a full dump of my stock F/W. can i ignore that my drive with the 02510C F/W isn't verfied, erase the drive and then use the old dump to spoof the new iXtreme v2.0 F/W?
2.Can the key be extracted from the 02510C F/w?
3.If i have to dumb the new 02510C F/w is there a way to do this without opening the drive i used the MRA method befor will i have to do it again?

 

[talby71]

here's a tutorial on how to get your key again http://team-xecuter.com/forums/showthread.php?t=66257
but the key you have should be fine as it doesn't change
to get it verified, have your drive all hooked up ready to be flashed, a;; firmware ready to go ,right click on the target box and click verify

 

[lockpicker]

firstly what is your set up. usbpro etc?

you have to open drive up and use probe v3 on point mpx01 to get the new 02510c firmware, then continue to put new lt2.0 on the drive