RGH my rgh will not power on! NEED HELP!!

GaterModz

Noob Account
Nov 3, 2017
2
0
I recently did a RGH my xbox 360 trinity, I left it on over night, and when i woke up, it was off so i pressed the power button and nothing happened, no sound, no light, nothing. so i bought a new psu and tried that. still nothing. it has a x360 ace v3, and the red light on the chip stays on for about 2-3 minutes before fading away. ive tried a new rf board, re flashing the nand. and nothing... does anybody know whats wrong with it, and know how to fix it? any suggestions?

https://i.imgur.com/Coksqbp.jpg
https://i.imgur.com/SYDtfEa.jpg
https://i.imgur.com/rn4ul3q.jpg
https://i.imgur.com/WpzPg1N.jpg
https://i.imgur.com/NOKSY22.jpg
 

Joo C

VIP Member
Dec 2, 2011
748
48
South Africa
Start by removing everything and flashing the retail nand to the console. It’s going to be the easiest way to diagnose what the issue is
 

GaterModz

Noob Account
Nov 3, 2017
2
0
I tried reflashing retail nand, but It got "flash config 0x0000000..." I will resolder the nand x wires and try again when I get home
 

BrockThunderjam

VIP Member
Jun 25, 2013
1,503
88
Uh-oh! Hot glue is not gonna be fun. Definitely heat it up before you start peeling it off so you don't remove any traces/components along with it. In the future I would not recommend using hot glue.
 

nofeloniesyet

VIP Member
Jan 16, 2011
4,830
128
Nowhere
Uh-oh! Hot glue is not gonna be fun. Definitely heat it up before you start peeling it off so you don't remove any traces/components along with it. In the future I would not recommend using hot glue.
meh,tbh i really dont think hot glue has that much of a hold on things. still wouldnt hurt to heat it a tad to remove it easier though.
 

BrockThunderjam

VIP Member
Jun 25, 2013
1,503
88
meh,tbh i really dont think hot glue has that much of a hold on things. still wouldnt hurt to heat it a tad to remove it easier though.
I have learned the hard way not to use it, I'll just say that. ;)
 

gavin_darkglide

VIP Member
Dec 14, 2012
2,303
118
I use hot glue on my installs, but I put a small dab on the board, then press the wire into it while it is still how, so if i have to remove wires, the peel right out of it.
 

darviral

Noob Account
Sep 1, 2020
2
1
darviral28
I recently did a RGH my xbox 360 trinity, I left it on over night, and when i woke up, it was off so i pressed the power button and nothing happened, no sound, no light, nothing. so i bought a new psu and tried that. still nothing. it has a x360 ace v3, and the red light on the chip stays on for about 2-3 minutes before fading away. ive tried a new rf board, re flashing the nand. and nothing... does anybody know whats wrong with it, and know how to fix it? any suggestions?

I have same issue do you fix it already?