My switch will not turn on

[chinman]

Hi All,

I had a brand new Nintendo Switch that I used the SX Pro on. Everything worked well. I turned of the Switch so I could add some of my backups to the MicroSD card. After inserting the card back into my Switch, the Switch will not turn on. I've seen the instructionals about holding down the power button for 10 - 15 seconds and then trying to turn it back on normally, but that didn't work. If you plug in the Switch, nothing comes up on the screen. When attached to my dock, nothing comes on the tv. Does anyone have any good suggestions on getting my Switch to turn back on? I don't know if it matters but my Switch is a model HAC-001. Thanks in advance.

Chinman

 

[chinman]

I did install AutoRCM. How do I get it out of RCM mode or what can I do to get it to turn back on? Thanks!

 

[RazorX2018]

I did install AutoRCM. How do I get it out of RCM mode or what can I do to get it to turn back on? Thanks!

you need to insert the dongle each time you switch your system on for the payload to launch, if you want to turn autorcm off again hold volume up and press the power button but keep the volume up held down until the sx os menu shows up again then you can just go into the options and turn it off again

 

[chinman]

That worked! Thank you Game_Over and RazorX2018! I'm back up and running!

 

[ddropski]

how do you do that if the battery is dead? ... rcm mode wont allow the batery to charge ( in fact it discharges it when you plug it in ) as i have read?

 

[ddropski]

so just to Verify your Running power into the dongle then into the switch ( using the donglr as a passthrough?) being that the dongle is a compositor is-int that risking blowing up the dongle ? i dunno LOL

 

[RazorX2018]

so just to Verify your Running power into the dongle then into the switch ( using the donglr as a passthrough?) being that the dongle is a compositor is-int that risking blowing up the dongle ? i dunno LOL

no you don't do that, see FAQ here: https://team-xecuter.com/forums/threads/154204-F-A-Q-Read-This-Before-Posting

it's a sticky at the top of the forum.

 

[ColdSpot]

Thanks it's working for me too.

 

[Tintoy]

I have the same problem. I put in auto rcm mode. but everytime i plug it in the computer and using the TegraRCMGui to check if it is in rcm and to inset the payload, my laptop cannot detect my device in rcm.