my x3 cannot use x3 bios

[TEKKEN_CHINMI]

1st i`m sorry if my english bad. I'm using x3 CE,control panel,xapt3r,xbox V1.1 or maybe V1.3 .and after i flashed first time my x3 with bios X3_3294 using bank 1234 it worked fine and nice,then i pushed long press power button to disable x3 and then my xbox couldnt work even if i pushed chip enable it's still not working but i could still flash bios. i even removed xapt3r and used pin header and it's still the same but when I use x2 or any hack xbox bios it works just fine and only x3 bios cannot works hope u guys can help and fix my problem . Thanks

 

[DJBOOBY]

try removing x3 switch board plug from x3 chip then try flashing x3 bios to chip it will flash banks 1234
you could have bad bios switch board

 

[TEKKEN_CHINMI]

i already tried that way but it still doesnt work, any other sollutions?? and thanks by the way

 

[DJBOOBY]

what are your switch set to when you flash the chip with x3 with the x3 controll panel your switch should be flash protect off (red light)
switch set too on (blue light) on off (on light) off or off on off off

 

[TEKKEN_CHINMI]

been there done that n still not working with x3 bios but x2 and any hack bios works just fine

 

[DJBOOBY]

try flashing x3 bios too 2mb bank all switch off

 

[freakzilla3333]

I'm not sure if the password settings are stored in the bios or on the chip seperately, but if they are in the bios, it could be that its a newer bios with a password set, and one of the new x3 bios releases has a bug that after you set a password it stops at the xbox logo. Try downloading a different release of the x3 bios and post results. Just a thought so don't flame if it's wrong.

 

[TEKKEN_CHINMI]

Finnaly I found the problem, one of the LPC`s is dead especially number 13 if u use the pin header. Now X3 CE run perfectly in my xbox and i even install xapt3r back to where it belong . Many Thanks for your help guys