JTAG nanad x wont work need help (pic}

Status
Not open for further replies.
X

xbox360guru

Full Member
Dec 11, 2010
37
0
Eastern Ontario, Canada
You say it's connected to the 360 but do you have the power supply connected also? If it's plugged in then like xbox4life asked post hi-res pictures of your soldered connection, your issue in most cases is always caused by a bad connection.
 
Last edited:
C

ClutchPlayer

Full Member
Jul 9, 2011
95
0
i just made new topic with a video its not high quality but i think you might be able to tell, i can assure you my soldering is good :/ idk what it is

ok so i got my nand x today and it is not working at all,
ok well to start off the qsb didnt work for the nand :/ so i had to manually intsall the wires.. wich at first worked, i read nand and all identicle.... but then when i went to install the jtag wires a nand wire came off, then all the nan wires got stuck together so i had to take them all off and back on and ever since it isnt working at all!! i connect every wire PERFECT! and it wont work... i turned on the xbox one time to be sure it still worked and it does.. i really need help on what to do someone please give me some ideas..

heres a video but quality is bad it is just to show that i have all hooked up, you cant tell its good put take my work soldering is very good

http://www.youtube.com/watch?v=Th_WRB13iXo

any suggestions is appreciated at this point i dont know what to do
 
Last edited by a moderator:
BGAMods

BGAMods

VIP Member
Jan 20, 2010
10,082
0
UK
bgamods.co.uk
NO you had started a new thread. ive merged the 2 as youre already receiving support in this thread.

1 THREAD PER PROBLEM PER USER.

oh and i cant see much in that vid so its not gonna help. we need high res pics of your install.
 
Last edited:
C

ClutchPlayer

Full Member
Jul 9, 2011
95
0
well my camera sucks :/ this is what i was thinking. i could get some desoldering braid, and take out all the solder in all those holes, then clean it out real nice and check for any burns.. ps: if one of those holes are slightly burned am i done for? and when i solder the wires on how should i do it to be sure i do it correct this time?
 
F

frazzeld

VIP Member
Jun 21, 2007
1,670
0
UK
you could end up damaging other pads unless you are really carefull, if you are going to attempt to clean out the holes you'll probably need a solder sucker...it would be a good idea to fit the pin headers

What size (temp - W) soldering iron are you using?

All is not lost unless you do more damage
 
C

ClutchPlayer

Full Member
Jul 9, 2011
95
0
i am using a 15 watt, and do you think i should use solder sucker or desolder braid? i will be going to store soon and need to know, thanks... and as for the pins i cut that wire to solder directly to the board, unless i can solder the wires back together to the pin header i cant use it
 
X

Xmods

VIP Member
Dec 9, 2002
1,431
0
borrow a friends camera you really can not make out anything from that video at least i can't

yes u can solder wires directly to the mobo

i personally prefer a sucker for through holes over wick
 
Status
Not open for further replies.