Nand Dump 512MB Jasper error

J

JohnO1234

Noob Account
Aug 2, 2011
7
0
Hi Guys,

I have an error coming up at the front of the Nand.
Error 205 at 0007
This is right at the front of the nand and where Xell is written to isn't it?

Two Dumps appeared to be the same and found the same error each time at the same place.

Is it possible to just continue along with my flashing etc.

Sorry if this has been posted before, but I can't see any post relating to a bad nand dump at the begining.

JohnO
 
J

JohnO1234

Noob Account
Aug 2, 2011
7
0
Ok, so the xell image I use is the one for a jasper and I open it up and remap the file to the blocks shown on degrader?
John
 
J

JohnO1234

Noob Account
Aug 2, 2011
7
0
Martin C said:
Does 360 Flash Dump Tool say it has a remapped block for this address?
Click to expand...
Hi I opened it up in the 360 flash tool but there is no mention of bad blocks.
How do I get the tool to pick up on the bad blocks. This is a big block jasper.

edit: It is a 204 error and not a 250 as previously mentioned.

I have two matching nand dumps fyi.
 
Last edited:
J

JohnO1234

Noob Account
Aug 2, 2011
7
0
Martin C said:
If they're not remapped then you may not need to worry about them.

Have you tried to write XeLL to see what happens?
Click to expand...
I am willing to go ahead, but what I would like to know is can I flash the original nand back without issue? I would assume the bad block would be taken care of anyway as it wouldn't boot otherwise.

I just want to check as I spent a lot of money on this one lol. I have done three Xenons and a Zepher but never had bad blocks in the first few MB.

Thats why I came here to be sure I don't pop my jasper :)

JohnO
 
You must log in or register to reply here.