RGH NAND issues

[Conscript_79]

So I have a 13604 dashboard Trinity 16mb Slim.
Installed NAND-X wires to read my NAND.
Flashed my CoolRunner to work with the Trinity.
Dumped 2 NANDs and both checked out fine. No Bad Blocks.
Created my ECC file.
Wrote my ECC file to the NAND.
Booted into XELL Reloaded using the eject button.
Took a picture of my CPU and DVD key.
Used CoolShrimp tool. Said the Key was valid.
Created FreeBoot gg13604.
Wrote it via NAND-X. Booted into the Dashboard. Used XEX Menu I used FreeStyle played some games.
After about 2 days I decided to go back to stock.
Removed the chip and wrote my original NAND back.

I then went online and updated to 14699 Dashboard.
Changed my mind again and I wanted to install the RGH. Did everything EXCEPT READ MY NAND. I figured I had my NAND and Key already so I would just flash the FreeBoot gg13604 file I had built before. Well I can boot into XELL Reloaded but cannot boot into FreeBoot.

I checked everything ECC files and soldering I am getting around 15sec boot times for XELL and 15 sec when the green light stops blinking on the coolrunner If I power it on using the actual power button.
I decided it could be my NAND image. Took the modchip out de-soldered all wires. Wrote my original back on and still wont boot up.

I think my motherboard needs a 14699 NAND and not a 13604 NAND. For either building a Freeboot image or just flashing it back to stock barebone.

Any help?

 

[keith6625]

your nand changes on every boot read this you should be fine

 

[Conscript_79]

Oh cool. I'll try it as soon as I get home. Thanks!!!

 

[Dimrain13]

your nand changes on every boot read this you should be fine

it doesnt change on every boot, on every update., i think that what u meant.

 

[Conscript_79]

Yeah it worked thanks a bunch. My LDV was at 5 when it needed to be at 6 which is the number of F's in my Fuse line 7 and 8. Changed the value in options.ini and created the new FreeBoot.