nand pin out

[XL3THAL VIP3RX]

got a repair on a slim to do and this is the problem.
one of the demon solder points is damaged,so the customer has tried taking a wire around to one of the nand legs and i think hes liffted were the leg goes to the board.
does anyone know if its possible or have a pic to repair this?ie scrape some trace and solder the nand leg to that?

id take some pics but my desire C 5mp camera is more like a 1.2 and the res is wank:frown:

 

[Martin C]

http://www.team-xecuter.com/forums/showthread.php?t=88368

This should help.

 

[XL3THAL VIP3RX]

http://www.team-xecuter.com/forums/showthread.php?t=88368

This should help.

i was looking at that one but wasnt to sure.
it looks like its the address patch enable ALE pin pad thats damaged.
so am i correct in saying i can take wire from that pin to the second trace bang above the nand?

if i boot the xbox it will boot but completley misses the splash screen and goes to dash,but if ya switch it off and then back on the fans go turbo lol,and then if ya try again she just bleeps at me unless i leave it a good half hour and it will boot again but still miss splash screen.

 

[Martin C]

A pic of the damage would be useful but yes, soldering from the leg of the NAND to the trace should repair it.

 

[XL3THAL VIP3RX]

A pic of the damage would be useful but yes, soldering from the leg of the NAND to the trace should repair it.

https://www.dropbox.com/s/djs5et99kqdzmyh/IMAG0054.jpg

this is best i could take martin,mi phones cack