I have a BB Japer 512 that was my first RGH. I knocked off a resistor while soldering the STBY_CLK. I did the alternate spot but I cant read the nand now. My soldering for the nand-x is perfect. Any suggestions?
Nand reading problem
- Thread starter crazed-cracker
- Start date
BL4K3Y
VIP Member
You need to replace the original resistor and/or repair the trace (if it is damaged) before you proceed.
Last edited:
Need a 33ohm resistor from trace to original resistor point
Sent from my LG-P999 using Tapatalk 2
Sent from my LG-P999 using Tapatalk 2
it wont matter. preferably an SMD, but if you dont have them, i know most radio shacks carry 1/2 watt 33ohm, and i have used them before.
EDIT, be sure to solder a small length of kynar to the resistor legs, its not good practice to solder the resistor directly to the board. it could put too much pressure on the pad or trace, and potentially pull it up
EDIT, be sure to solder a small length of kynar to the resistor legs, its not good practice to solder the resistor directly to the board. it could put too much pressure on the pad or trace, and potentially pull it up
Last edited:
I tried a 1/2W 33-ohm it still wont read and i tried a 1/4 330 ohm and that doesnt woork either. Any more suggestions.
Statecowboy
BANNED
Martin C
VIP Member
this is what i figured was going on, i thought itd be easier to see in pics, than to explain!!
i windered if he was using the resistor in-line with his alt point, instead of repairing the damaged point
http://www.team-xecuter.com/forums/showthread.php?t=81491&highlight=33ohm+resistor
this is a simple way of repairing it. worth a try.
this is a simple way of repairing it. worth a try.