Nand replaced, how to install dvd key to nand?

N

NewGen01

Full Member
Nov 8, 2014
32
6
I've a dead corona 4GB. The nand chip was dead. Replaced it, now working well. There is no DVD ROM inside. I'm got an DVD drive DG-16D5S with dvd key.
Tried to patch nand with this dvd key and write into it many times but allways only VIDEO DVD message if put in any original game disc. Anyone have a step by step tutorial how to build an working image for it?

Thanks.
Here is the nand and cpu key:
http://www.filedropper.com/4gbnand

Here is the new dvd key:
LITEON-DG16D5S
AA6AFD34DED2D5ACFEA8FDF7D59BB6AD

Thank You!
 
Last edited:
andoryuu3

andoryuu3

VIP Member
Dec 19, 2015
56
13
If I recall correctly, there's two ways to do it in J-Runner. One way is to go to the "Advanced" menu, then go to "Patch Nand" and input the DVD key there. If I were to guess, this is the way you've already attempted to do it.

The other way to do it is to go to the XeBuild section of J-Runner (top right corner) and click on the XB Settings tab, then click "Advanced XeBuild Options", and then paste your DVD key in the field next to where it says "dvdkey". Click OK, then the "Use Edited Options" box should be checked. Make any additional changes you need for either XeBuild or Dashlaunch, then create your new XeBuild NAND image. :)
 
andoryuu3

andoryuu3

VIP Member
Dec 19, 2015
56
13
Did you use the nofcrt patch as well?

Make a new patched NAND the same way you did before, except this time there's one more step. In the XeBuild section of J-Runner (top right), click on the "Patches/Dashlaunch" tab. On that tab, the first checkbox should be "nofcrt". Make sure that is CHECKED, then click "Create XeBuild Image" whenever you're ready.
 
You must log in or register to reply here.