I just received my nand-x and coolrunner. With nand-x also came with the jtag Xecuter Nand-X QSB Install Kit. My question is how or where do I solder the coolrunner to the nand-x qsb kit and to the board. Or do need the coolrunner QSB kit?
JTAG Nand-X and Coolrunner
- Thread starter barryc2112
- Start date
Martin C
VIP Member
You can use these and solder the 3.3v wire to the point on the right hand QSB. The rest of the install would need to be wires though. Otherwise you'll need to get the Coolrunner QSB kit.
those qsb's are only for jtag and yes you need the optional coolrunner qsb's instead or use direct wiring.
---------- Post added at 19:26 ---------- Previous post was at 19:24 ----------
---------- Post added at 19:26 ---------- Previous post was at 19:24 ----------
did that once just because i had the qsb's spare and it was a pointless venture without the other wire points on a qsb. direct wire is so much easier and safer imo.
barry they can be used, ive used them on alot of my RGH phat consoles when i couldnt get hold of the coolrunner QSB's
Martin is correct (as always) as I myself used the same boards to do my RGH. Only difference is you need to use wires for I think 3 connections (Ground to USB Port Casing - see pics)(3.3 v red wire from coolrunner to 3.3v on nandx board - the one without the hole the middle) and (coolrunner orange wire to point R4B24)
Helpful pic
http://www.team-xecuter.com/forums/showthread.php?t=74689
Helpful pic
http://www.team-xecuter.com/forums/showthread.php?t=74689
Last edited:
exactly and the whole point of the qsb is for the plugs so as i said a pointless venture, if you still need to chop up a nandx cable to use it in a glitch i just dont see the point in it. just buy the rgh qsb its like £3 if you must use a qsb.
---------- Post added at 20:16 ---------- Previous post was at 20:12 ----------
also everyone seems to forget there is the jtag only qsb in there too and to use that would be a mistake and a half so this is getting confusing to the op now. how long till he comes back saying i've installed all the qsb's but i see no this that and the other and whats this for, if you get me.
---------- Post added at 20:16 ---------- Previous post was at 20:12 ----------
also everyone seems to forget there is the jtag only qsb in there too and to use that would be a mistake and a half so this is getting confusing to the op now. how long till he comes back saying i've installed all the qsb's but i see no this that and the other and whats this for, if you get me.
Dont look like OP is confused. He posted pics of only the nandx boards complete with plugs and he appears to know that you dont use the jtag boards. And the nandx cables with plugs come with the nandx
Last edited: