Nand x causes red PSU light

C

CharleJones

Noob Account
Feb 28, 2012
9
0
I am practicing my soldering skills and rgh installation on a board that i got for free, but it worked before it just didnt have a dvd drive, so i was going to rgh to get the original key and all of its information. However i have everything soldered and i went to hook up the nand x to read the nand and i get a red lgiht on the PSU. the 360 boots just fine so i dont think its the wire install. i just cant figure it out. also my computer has stopped recognizing the nandx which i have used successfully before. the lights come on as normal but isnt recongized. Did i fry my nandx? any help is much appreciated.
 
C

CharleJones

Noob Account
Feb 28, 2012
9
0
I tested the nand x with another computer and it was recognized, so i decided to trouble shoot the connection that was shorting out the only thing that i noticed was when i attached the ground wire to the av port i got the red light. so i have de-soldered all the wires and im gonna re solder everything and see what happens.
 
C

CharleJones

Noob Account
Feb 28, 2012
9
0
I figured out the problem and read my and correctly, check that it was correct but not jtag tool, j runner and 360 flash dump tool are telling me i have a bad kv/key but i have checked my key at least 10 times, i looked into injecting the keys into a donor nand dump but i cant seem to get it to work. I have followed a couple tutorials, but i still cant get it to work. :facepalm:
 
You must log in or register to reply here.