RGH Nand-X dont read after update to V3

[Yagamiar]

I was installing a CoolRunner on a Xbox, read the original nand ok, after that i realized there was no parallel port on the computer I was using, so I decided once and for all upgrade my nand-x v2 to program the CR, after upgrading go to program and install the CR ithout problems then boot the xell, get the cpu key and build the new image to flash, so then i could´t write or read any more with my Nand-x. The wiring is the same installed when i read the original nand and when flash the xell.

i´ve tried to go back to v2 but its the same

In v3 with nandpro 3 i get this:

NandPro usb: -w16 nand3.bin
NandPro v3.0a by Tiros

Looking for usb interface device
Can not continue

In v3 with nandpro 2 i get this:

NandPro usb: -w16 nand3.bin
NandPro v2.0b by Tiros

Looking for usb interface device
Incompatible ARM hardware for this version of NandPro!
Can not continue

and vice versa in v2 with nandpro 2 i get the msg "Looking for usb interface device,Can not continue" and with nandpro 3 i get "Incompatible ARM hardware for this version of NandPro!", also when the nandx is in v3 i can program any coolrunner(verified 3 diferent ones with the lpt programer).

there is any other file to flash with flash magic?

 

[oO Elite Oo]

Try Jtag Tool and show a picture of your connections...

 

[manwithoutname]

If nandpro doesn't work directly, using jtag tool won't make any difference. The problem lays either with nand-x or drivers.

 

[Yagamiar]

I´ve solved half of the problem, the nand x it´s ok, the problem was the r4b24 that got open replaced and now I have a nice 0022 RROD