RGH Nand-X dump without QSBs

[BHL ADDZ]

Hey All

Just this morning I tried to RGH a Falcon but the Xbox was broken to start with so I got another to work on, because I unsoldered the QSBs they weren't in the best shape I then continued to solder them to the new Falcon but one of the points burned off!!

I'm wondering if I can use Nand-X with the bottom QSBs and somehow just wire the top part or if there was a way to use Nand-X with a full wired version and get rid of the QSbs?

~ ADDZ

 

[axee44]

U can use pin headers cables that were supplied with your nand-x. Just cut pin headers off and solder it directly to xbox motherboard. There is simple tutorial in nand-x support forum.

 

[BHL ADDZ]

U can use pin headers cables that were supplied with your nand-x. Just cut pin headers off and solder it directly to xbox motherboard. There is simple tutorial in nand-x support forum.

Thanks a lot I'll look for them now and try find a tut.

Here was an image but axee44 has been more than helpful Thank You
(Ignore the bad soldering that's not been soldered down yet it's old solder from lifting it on the broken Xbox, the red mark is the burned off point but I'm going to try a wired version and the pin wires...)

 

[snake007]

Hi I always solder the wires directly to the motherboard. I find it much easier. I had a falcon the other day that someone had messed up the qsb on top badly. So I done a direct wire to the motherboard underneath and it worked fine to my surprise lol

If you go on jrunner and look in the image tag at the nand-x x install it shows you where to solder the wqires and what colour go where

 

[Ticallion]

There was a good thread where people showed they attached resistor legs to the ends of the wires and it makes for a very easy nand read which can easily be removed after, I've taken to doing this for phats, only use QSB's for slims now.

Can't find the thread in question at the moment, but have a search round it's out there.

 

[garageinc]

like this

 

[Ticallion]

That's the one.

 

[bandit123]

that green plug on the QSB looks damaged aswell looks like its been melted

 

[BHL ADDZ]

I got it all sorted with wires and it was much more easy than I 1st though it would be BUT!!

Checking the file nanddump.bin, Please wait...

* found flash image, unpacking...
ECC'ed - will unecc.
Found 2BL (build 5773) at 00008000

[CB] version [5773] found !!

This CB version is not compatible with the Glitch Hack

The Xell/ECC image won't be created


Press any key to continue . . .

^ Does that mean I'm screwed yea?

 

[Mungus]

For the time being, Yes.

 

[BHL ADDZ]

Thanks a lot everyone

Bring on RGH2.0

<3 T-X

 

[vrtclhykr]

First thing I did after seeing that post with the resistor legs is chop up a cable and make one like that . Works awesome for doing wire installs. Cudos to the original poster. I have not used any qsb's except for POST on slim's with low loss coax since making that cable.
Save yourself a few bucks on each install.