hey everyone I installed my nand-x using the pin headers this morning my jtag is already done and setup prior to getting the nand-x but my question is I went ahead and did 2 dumps of my nand as it is now and coolshrimp jtag tool (thanks a bunch by the way coolshrimp nice program) compared them and said no non-matching blocks found does this mean that everything is soldered up good and no problems was found I assume so but this is my first jtag box and wanted to make sure I assumed if any problem with soldering was there is would come up with non matching blocks? thanks ahead of time for help.
JTAG nand-x general question
- Thread starter hopper47
- Start date