Nand-X header pin cables.

[gomson]

Hi guys,
I've just purchased the nand-x package and used it to successfully jtag a jasper 512mb BB console. I was wondering, do you guys sell the nand reading cable by itself..?

I mean the one that has the male pin header pins on one end and the part that connects to the usb nand reader on the other end..?

I know you sell the nand reading quick solder board on it's own, but what if I wanted the cables as well to plug into the quick solder board then the nand reading device..


I hope that makes sense...

Thanks

 

[manwithoutname]

Unfortunately the cable you refer to does not exist as a separate part for sale and can only be obtained in the whole NAND-X package. We have discussed this here before but it doesn't seem to be there are any plans at least for now for TX to make this part available on its own. Yet I believe there is a growing demand for it and I feel it will sell as well as the other JTAG parts (I my self would buy few in one go if they existed).

So for the time being you'll have to find another solution, perhaps make your own connector!!!!!

 

[gomson]

thanks mate. I was afraid of that...
Hopefully they'll re-consider cause I think it would be a real shame to have to buy the whole nandx package again just for that...