JTAG NAND-x help

[jhaymes2006]

So on the new reset glitch if I just use the wires, when I get my NAND from the NAND side, would I have to resolder the wires, to do the jtag later. What I mean is the jtag is on the coolrunner so I wouldn't need thewires hooked up after I got my NAND right.

 

[srt4fun]

Once the .ecc and Xell Reloaded are flashed then you shouldn't need your nand hookups. Should be able to flash through Xell. Although, I'd leave them just in case. The Coolrunner will need to stay (unless you're just getting a lost DVD key).

Just had a look at http://libxenon.org/index.php?topic=147.0 Apparently nand flashing is disabled atm...so your nand hookups will need to stay until there is a Xell Reloaded update or a rebooter.

 

[jhaymes2006]

No I was just going to extract the NAND and unhook the NAND-x side of the wires, and wait on the coolrunner to do the jtag.

 

[bigO73]

I'm with you. There will be all kinds of questions, but I'm sure the team will have a good guide and Q&A when the coolrunner comes out. I will just wait a couple weeks after its available to see how everything pans out. These door stop boxes I've been sitting on with no key aren't going anywhere anytime soon.

 

[diaboliq20]

afaik - The wiring from the glitch runner (i.e. coolruner) is soldered to different points - one of them quite difficult.....the wiring for reading the NAND and the wiring for attaching the glitch mod are different