I was reading the nand on a phat and noticed nothing was happening so I looked at the pin I soldered to the board. When picking up the tools I laying around I must have hit the cables because the red cable was broken at the base (Use resistor legs) and touching the black wire. I resoldered it back to the board and now all I get when I try to read the nand off any xbox is "Flash Config: 0x00000 Cannot continue".
Any ideal what I have done or does anyone know a fix.
PS: I'm using my homemade USB SPI FLasher for now but can't use it with J-Runner because the Arm version, but I love my TX products. :frown:
Any ideal what I have done or does anyone know a fix.
PS: I'm using my homemade USB SPI FLasher for now but can't use it with J-Runner because the Arm version, but I love my TX products. :frown:
Last edited:
