JTAG Nand-X kit for Xenon & Zephyr?

[Johnny8675309]

Alright about two weeks ago I asked if a single Nand-X kit will be sufficient to do both Xenon and Zephyr consoles I have. M AzeeM K said it was enough so I finally got my kit in and have begun working with the Xenon first. I soldered up the NAND QSBs and am about to do the JTAG QSBs but I started wondering what I'm supposed to do when I need the JTAG QSB (w/ resistor switch) for the Zephyr board? I already had the BoxxDR's transistor mod on the Zephyr which I failed to JTAG because I didn't have the NAND-X so it wasn't flashing properly I suppose so would that be sufficient? After I flash the Xenon could I apply BoxxDR mod after so I can reuse the QSBs?

 

[M AzeeM K]

Seems like I completely misunderstood what you asked before. Sorry for that.

So, right now you're doing the Xenon. Keep on going until you've jtagged it.

After that, you'll start working on the Zephyr. In this case, since the Jtag wiring is already present, you don't need to do the Jtag part here. All you need is a way to read/write to the NAND. So, here you can either use the Pin Headers or do a Direct Wire install. Its upto you which method you choose.