DRIVERS NAND-X not being detected by Nandpro / JTAG tool

V

Vest1ge

Hay,

When i attempt to read any NAND with the new NAND-X (bought direct from china distribution with new v3 code) neither NandPro cmd or the JTAG tool are detecting the NAND-X i've installed the drivers and it appears in device manager correctly, but cant use it in these programs.

I've tried on two different computers both running windows 7 64bit
 
V

Vest1ge

It goes:

Looking for usb interface device
Can not continue
Press any key to continue . . .

See picture:
 
T

thebomber

VIP Member
Jul 25, 2010
628
48
Cairo/Egypt
i guess you dont have power connected to youe console

just plug it in the xbox and dont turn it on it should be ok if your soldering is all ok as well
 
M

Mthodmn101

VIP Member
Sep 3, 2011
97
13
Several users have had this issue, including me.... i havent gotten it resolved
Tried on my two consoles, one jasper and one slim, same error, worked fine before on 2.0e, not after upgrading to 3.0

Unsure of whats wrong, sent back to reseller
 
V

Vest1ge

EXACTLY UBERGEEK!

Namely while i put the driver tag, as its not even getting to the point of connecting to the NAND-X

EDIT: Just discovered i can program a cool runner chip.... So its a problem directly related to the reading/writing section
 
Last edited by a moderator:
M

Mthodmn101

VIP Member
Sep 3, 2011
97
13
my connections are fine, it dumped nand fine on 2.0, updated to 3.0 to program coolrunner and then it didnt read nand anymore, on either console.

needed to borrow someones usb spi one to do it
 
Racoon

Racoon

Full Member
Aug 3, 2011
37
0
Australia
I have the same thing.
I read and wrote the NAND on a slim this morning
Now nothing keep getting the same "cannot detect USB"
Help plz
I had upgraded to the v3 2 weeks ago and it has been fine till now..
 
Racoon

Racoon

Full Member
Aug 3, 2011
37
0
Australia
Cut my wires back, re tin them, Put them back on...
Perfect , works great. :smile:
 
Last edited:
mickeyvilla

mickeyvilla

Full Member
Mar 30, 2011
78
0
birmingham WM UK
i'm sick of getting told this is down to soldering.

i've used qsb & fitted them perfectley even checked with a jewlers loup to make sure of a good solid weld,no shorts or bridgeing.tested solder points to plug that go's to nand-x all perfect,but still get "cant find usb device".

i've even desoldered the qsb's examined the board for any burnt tracks,nothing perfect as i thought in the beginning.

i've soldered wires direct to the board perfect neat job,no shorts nothing.

but still getting "cant find usb device"

its either down to nand-x units/drivers or win compatabilty issues

maybe this new usb update cable i've heard of is gonna be the answer
 
Last edited:
You must log in or register to reply here.