Nand X Pin header install on Falcon Board ????

[rideblue151]

Ok I have a few question maybe you pros can answer just as a precaution on my part..

Q.1 I did a falcon board jtag already with the Nand x im using.. Is it ok to just connect it to the next xbox? The nandx does not retain any info of the old xbox rite??

Q2 pin headers there only 2 of them the solder the 2 on the one jb section and the other i think 5 in the other jb section. Then plug into the nand x and to computer and im good rite??

Q3. The jtag part would be exactly as if you were using qsb.. Just run 2 wires one from rol and dbf1.. WITH MY OWN (WHAT) diodes or resistors which ones and size theres a lot of posts of using different ones.. This is a Falcon board whitch is best for this app??? Thanks guys any other comments would help
this is the first time im using pin headers
and the tut shows good pict of the 2 headers but not jtag part Just being cautious please dont be mad. I want to succeed not Be doing the @^#%@^# up a storm crap cause I was to lazy to ask a question.....

 

[M AzeeM K]

Q1. Yes, you're right. You can use the Nand-X as many times with as different Xbox360s you want.

Q2. Yeah, correct.

Q3. Yes. All you have to do is to connect the Jtag wires with diodes at the correct points. Also, if you want, you can alternatively try THIS too.

 

[rideblue151]

ok pin headers installed. Done I connected the jtag portion to the rf board a dbf1 with normal switching diodes like said in tut with the black line on dbf1 side and black line on rf board side. dumped nand 3 times all 3 matched 0 blocks.. Sweet i powered on and 3 red lights and nothing on the screen my soldering is good the pin headers i soldered from the back side of the board and filled them full the other 2 on j2b1 i cut wires and put them in the holes filled with solder. i have the jumper wire in place soldered nicely as the tut.. please help with what to try

 

[rideblue151]

so this is a new one to me so i tried switching the jumper wire with a 330 resisor and write xell. I acts like it wants to boot then throws the 3 red lights.. So figured lets try a 470 ohm resistor.. 3 green lights came on lol then they swaped to 3 red lights.. Now this i have never seen or heard of whats your thoughts on this one everyone?????????????????

 

[marshamods]

does it work with orginal dash? What is the secondary error code, if the wiring was bad it would be e79