I think we can flash a specific hex to get some data through the nand-x to debug a rgh/jtag...how useful and accurate this method ? Is it similar to the rater for the old coolrunners?
thnx
thnx
JTAG Nand-X post logs
- Thread starter mat989
- Start date
Martin C
VIP Member
You still need a level shifter to use a NAND-x on v3 code.
So a CR3-Pro/R-JTAG etc is still required.
So a CR3-Pro/R-JTAG etc is still required.
Sorry I did not get that level shifter hint. I plan to use coolrunner rev C on a fat console for RGH perhaps. I still remember that the developer for nandpro released a set of hex files for usb nand readers, they did help to get some logs...but I am not sure how helpful they were. I have multiple usb readers, from different sources...and I plan to dedicate one of them for such purpose if it is really helpful...
thnx
thnx
Martin C
VIP Member
I do have R-JTAG chip that will be used on a fat console, and a CR3-Pro for a corona...then I have rev C coolrunner...I thought of using that one on a fat console for RGH perhaps...and obtain some useful logs using one of the nand readers...I think I will check xboxhacker -if online- for further info...
thnx
thnx
Martin C
VIP Member
You only have to wire it up temporarily to get POST_OUT.
POST_OUT is disabled on newer stock dashboards too.
POST_OUT is disabled on newer stock dashboards too.