nand x problem with psu

[f3ar666]

Hi hope im in the right place as im new. Every time i plug the nand x into the usb on the pc, The power supply light turns red so i disconnect every thing, and reconnect, everything is ok but xbox wont start at all so i plug the nand x in again and led turns red again. I have read through and cant find anyone with the same problem, can any one please help thank you

 

[BGAMods]

so you plug the nand-x into the usb on your pc/laptop and you have 1 red light on the nand-x?

you should have 2 lights on the nand-x. have you installed the nand-x drivers?

or do you mean the actual 360 power brick turns red?

 

[f3ar666]

Hi yes i mean the power brick led turns red

 

[modmonster]

Can you post a high res photo of your install. Red light on power brick ....bad.

 

[f3ar666]

Hi sorry it took so long had to find camera this is the best i can get it. I have disconnected jtag now but it did the same thing when it was on there.

 

[BGAMods]

cant tell you nothing from that pic. need a close up of your soldering, are you 100% sure theres no short in your soldering?

 

[f3ar666]

im not that good at soldering but the reading and writing of the nand has been ok. if i short out certain pins on nand chip at the same time as plugging power in the nand reads and wrights but then the lrd turns red after doing it, if that helps. Here is my soldering not pretty lol.

 

[M AzeeM K]

Probably during soldering, you have bridged two points which are not supposed to be bridged due to which there is some kind of short-circuiting on the motherboard. Due to the short-circuit, whenever you try to turn on your Xbox360, the PSU's light turns red.

I suggest you look for any such unnecessary bridge, plus if there's some extra solder present on some points, you should clean it too.

And last but not least, post some High Resolution pictures of the soldering.

 

[f3ar666]

I dont know if these pics help but i think you could be wright as my soldering is rubbish

 

[BGAMods]

that soldering is terrible, clean it up and then test.

 

[manwithoutname]

I dont know if these pics help but i think you could be wright as my soldering is rubbish

Clearly there is excessive solder on some of these points. I'm not surprised that your xbox has got short circuit somewhere ... Remove the excess soldering and try again ...

 

[Xecuter]

That soldering is shocking - no wonder its not working

 

[f3ar666]

Lol i will i do agree with you seeing it in high res really dosent help, thank you will let you know if i get it working or not.

 

[M AzeeM K]

Lol i will i do agree with you seeing it in high res really dosent help, thank you will let you know if i get it working or not.

I hope your cleaning skills aren't as your soldering skills . If you clean the points nicely, plus if you haven't damaged any point or anything near the points with the soldering you have done, your Xbox360 should start working again.

 

[f3ar666]

Hi all i desolderd and cleaned it then resolderd a little bit better than before and it works now. Thank you for all your help. I just have to get past jtag problems as its a cb 4580 and im having nothing but problems.

 

[M AzeeM K]

Follow the official Nand-X tutorial precisely. If you have any questions regarding, feel free to ask them.