Nand X Spoilt JTAG QSB Need Alternative Wiring Plan help

[allmobile]

Please help

Have spoiled the JTAG QSB (one with the switch on board)

Part that is burnt is the pount that is next to the '370' printed on the QSB

Have managed to dump nand no problem but cannot instal XELL without E 79

However can write back original Nand so that is strange?

Is the solder point the cause or is that solder point just an anchor point

I do not want to remove the two Nand Boards

Thanks for any help.

 

[garageinc]

what board revision is it? if its just the jtag qsb you messed up just direct wire it to the points or are they fubared too? photo's would help.

 

[allmobile]

Board is all OK

If if use wires do i need resistors

What wiring points do I use.?

Thank you

 

[M AzeeM K]

Have a look here: Jtag Alternate Points

 

[allmobile]

solved Thank you REP +

 

[M AzeeM K]

^ No Problem