FIXED Nand X Stopped Read/Write

V

Vest1ge

Hay,

I've had my nand-x for a while now.
Done a number consoles and never had any issues.

But I have started suddenly getting Can Not Continue with every console.

And have checked all my connections with a multimeter to the other side of the board, to the other side of the connector of the NAND-X and soldering is GOOD.

Reflashed V3 code.
Reloaded Drivers
Used NAND Pro via CMD and J-Runner

Any suggestions?
 
BL4K3Y

BL4K3Y

VIP Member
Jul 7, 2010
13,721
118
Colne, Lancashire (UK)
I have attached an image for you, test each of the pins marked in red using continuity on your multi-meter.

(Credits to faz2k2000 for the image, I couldn't find my camera).

I am not sure if this is what you meant when you said you had already checked.
 
Last edited:
V

Vest1ge

BL4K3Y said:
I have attached an image for you, test each of the pins marked in red using continuity on your multi-meter.

(Credits to faz2k2000 for the image, I couldn't find my camera).

I am not sure if this is what you meant when you said you had already checked.
Click to expand...
BL4K3Y, Yes I tested those to the other side of the board from were I soldered my wires too.

All checked out good
 
Last edited by a moderator:
V

Vest1ge

Evil0ne said:
how old is it and have u tried power cycleing it while holding the reset button?
Click to expand...
It was one of the first with the V3 code. Got it from China Distrib

And just tried that (why i waited to reply) and no luck, with confirmed connections.

Any other suggestions?
 
Ubergeek

Ubergeek

Xecuter Groupie
Feb 24, 2003
6,259
0
California, USA
I find that they get damaged with poor wiring or when you try to program coolrunners while installed to the Xbox and prg switch is incorrect or jtag cable plugged in the wrong way around.
 
V

Vest1ge

Ubergeek said:
I find that they get damaged with poor wiring or when you try to program coolrunners while installed to the Xbox and prg switch is incorrect or jtag cable plugged in the wrong way around.
Click to expand...
Uber, wiring was good, and I have never had any issues with my wiring.

And I always disconnect the plug that connects the wires to the Nand-X when its not programming.

Martin C said:
Does your NAND-x still program Coolrunners ok?
Click to expand...
Yes it still program's them.
 
V

Vest1ge

Thanks Webnomix for all the help you gave me. My NAND-X is still buggered but helped me get that console finished!

He knows his stuff! And is no noob!
 
You must log in or register to reply here.