Nand-X Troubles, Using Jtag Tool

[JTaGxSTaCKz]

Hey guys, im having a little bit of trouble with nand-x as it cannot read the nand, i am using pin heads. Here are the pics: View attachment 4328

View attachment 4329

View attachment 4330

View attachment 4331

 

[frayed]

holy sh*t, you making toast or something?

 

[frazzeld]

what error are you getting

 

[*HDCM]

clean off flux residue and see if you've caused any damage to the traces around those points.

 

[JTaGxSTaCKz]

Hahah first try, I've only just gotten into it, sorry it's so sloppy
The device cannot find the flash controller.
I'll try cleaning off the residue.

 

[frayed]

start by reading here

http://www.team-xecuter.com/forums/showthread.php?t=54748&highlight=detect+flash+controller

 

[JTaGxSTaCKz]

Thanks Frayed, makes me look like a d**khead though haha, ah well gotta start somewhere ay?

 

[frayed]

its all good man

 

[JTaGxSTaCKz]

The points are all clear, none of the traces are damaged. Would i be better off, un-soldering and then re-solering the pinheads?

 

[J2G]

That Cap in the pic looks like it had its day buddy or my eye site is gone and you could do with a multimeter so your not playing the guessing game and get some flux cleaner..

 

[JTaGxSTaCKz]

how do i use the multimeter on the board and what am i looking for?

---------- Post added at 11:40 ---------- Previous post was at 11:37 ----------

how do u use a multimeter on a motherboard and what am i looking for?

 

[J2G]

They are cheap enough and very handy in this game..

[ame]http://www.youtube.com/watch?v=bF3OyQ3HwfU[/ame]

 

[WNYConsoles]

I stay away from the pin headers myself, they are tricky to install and can cause damage, try using the wires instead.

Additionally, just to confirm with you that you need to supply the XBOX Motherboard with power to read the NAND. Plug the Power Brick into the XBOX Motherboard, make sure your Power Brick Light is Orange, power in the NANDX, and you should be good to go.

Hope this helps.