Indestructable
VIP Member
Re: NAND-X units R a load of s**te
i got a nand x here mate your welcome to use if your stuck:biggrin:
NAND-X units R brilliant when used correctly :)
- Thread starter mickeyvilla
- Start date
Re: NAND-X units R a load of s**te
for god sake i only want to read & write the nand there are NO SHORTS,BURNT OUT TRACKS EVERYTHING MEASURES UP ON MULTIMETER.
I DID HAVE QSB'S AT FIRST ON XENON UNTILL I GOT TOLD ITS DOWN TO SOLDERING SO I WIPPED THEM OFF & WIRED DIRECT
for god sake i only want to read & write the nand there are NO SHORTS,BURNT OUT TRACKS EVERYTHING MEASURES UP ON MULTIMETER.
I DID HAVE QSB'S AT FIRST ON XENON UNTILL I GOT TOLD ITS DOWN TO SOLDERING SO I WIPPED THEM OFF & WIRED DIRECT
Indestructable
VIP Member
Re: NAND-X units R a load of s**te
it is the nand-x unit & i will prove it once i get this faulty 1 exchanged
it is the nand-x unit & i will prove it once i get this faulty 1 exchanged
Last edited:
sherlock
Troll Eating Dogs
Re: NAND-X units R a load of s**te
ok,
it's no use keep going over this, no one is saying 100% it's your soldering that is the problem, nor are they saying the nandx isn't the problem.
you can either redo everything again with the advise that these guys have given you or leave everything as it is and ask for a replacement.
then if/when you have a replacement connect it up again and see how it goes.
ok,
it's no use keep going over this, no one is saying 100% it's your soldering that is the problem, nor are they saying the nandx isn't the problem.
you can either redo everything again with the advise that these guys have given you or leave everything as it is and ask for a replacement.
then if/when you have a replacement connect it up again and see how it goes.
Re: NAND-X units R a load of s**te
the mods & every 1 who are telling people this will end up with egg on their faces if it is down to some of the nand-x units.
and you'll of got 100's or 1000's of people fluking their mobo boards for no reason
i would liked to be helped its just that i'm sick of being told its down to wirering & bad soldering.
the mods & every 1 who are telling people this will end up with egg on their faces if it is down to some of the nand-x units.
and you'll of got 100's or 1000's of people fluking their mobo boards for no reason
Re: NAND-X units R a load of s**te
They sent an replacement and this also did not work so it was down to my pc set up or my sh*te soldering. in the end i sent my board to manwithoutaname.
so as you can see from my experience it is usually down to what has been stated and bad set up or soldering skills
99% time it is down to the soldering however i can confirm i did receive a Nand-X about a year ago from CK3, they replaced it for me after sending it back because i thought that was faulty.
They sent an replacement and this also did not work so it was down to my pc set up or my sh*te soldering. in the end i sent my board to manwithoutaname.
so as you can see from my experience it is usually down to what has been stated and bad set up or soldering skills
Re: NAND-X units R a load of s**te
i'm using win 7 on 64 bit & tried it on another 2 computers 1 running win 7 64 bit & xp 32 bit.
when i read the 2 nands & wrote xell to nand i used coolshrimps jtag tool the l8est version.
yes bandit i've reset the nand-x flasher i've uninstalled the v3 & just tried the v2 drivers reset computer.
i'm using win 7 on 64 bit & tried it on another 2 computers 1 running win 7 64 bit & xp 32 bit.
when i read the 2 nands & wrote xell to nand i used coolshrimps jtag tool the l8est version.
Your soldering looks terrible dude !
Some of the contacts aren't even covered, and don't look like you used flux !
There will be the odd faulty unit but most problems are down to pebkac
Modtraders will test and replace it for you no problem
Some of the contacts aren't even covered, and don't look like you used flux !
There will be the odd faulty unit but most problems are down to pebkac
Modtraders will test and replace it for you no problem
Re: NAND-X units R a load of s**te
ive seen far far worse posted on the forumYour soldering looks terrible dude !
Re: NAND-X units R a load of s**te
The solder hasn't melted properly and has never seen flux which is only going to cause problems
That doesn't make his any better lol :facepalm:ive seen far far worse posted on the forum
The solder hasn't melted properly and has never seen flux which is only going to cause problems
Re: NAND-X units R a load of s**te
hmmm similar problem here??
http://www.team-xecuter.com/forums/showthread.php?p=490013
hmmm similar problem here??
http://www.team-xecuter.com/forums/showthread.php?p=490013
Re: NAND-X units R a load of s**te
thanks n1ghtowl i too have seen far far worse soldering & it does'nt help when u get told its down to your soldering so your desoldering & resoldering time after time.
---------- Post added at 15:39 ---------- Previous post was at 15:35 ----------
just for your information i did use flux & as i've all ready stated all wirers are correctly attached to the mobo i've tested with mulitmeter.
thanks n1ghtowl i too have seen far far worse soldering & it does'nt help when u get told its down to your soldering so your desoldering & resoldering time after time.
---------- Post added at 15:39 ---------- Previous post was at 15:35 ----------
see i'm not the only 1 thats why i started this thread i truely believe its down to the nand-x unit it can not be anything els as every thing els has been eliminated.
Re: NAND-X units R a load of s**te
Send me your Nand-X to test, I have 3 that have never failed, if yours is faulty i'll send you mine while modtraders sort your replacement out... I can't help any more than that but I honestly see problems with your soldering, what iron are you using ?
Send me your Nand-X to test, I have 3 that have never failed, if yours is faulty i'll send you mine while modtraders sort your replacement out... I can't help any more than that but I honestly see problems with your soldering, what iron are you using ?
Re: NAND-X units R a load of s**te
if his retailer is telling him its down to the v3 drivers why has'nt tx picked up on this & done something about it,instead of telling every 1 its either down to bad soldering or wirering.
Re: NAND-X units R a load of s**te
I just received a nand-x and two coolrunners yesterday, and installed both to one of my banned systems. Couldn't get it to read in nandpro, (at best it would attempt with errors on every line), but I had to leave and couldn't finish up. Before I was using a homemade nand programmer I purchased from the xbox-scene forums and this time around it was much easier with the quicksolder boards. I'm not going to blame my tools because it didn't work first try when these are the best available right now. If Xecutuer's tools aren't doing it for you, get a replacement or build your own. It's obvious you're frustrated but it's not their fault at all.
I just received a nand-x and two coolrunners yesterday, and installed both to one of my banned systems. Couldn't get it to read in nandpro, (at best it would attempt with errors on every line), but I had to leave and couldn't finish up. Before I was using a homemade nand programmer I purchased from the xbox-scene forums and this time around it was much easier with the quicksolder boards. I'm not going to blame my tools because it didn't work first try when these are the best available right now. If Xecutuer's tools aren't doing it for you, get a replacement or build your own. It's obvious you're frustrated but it's not their fault at all.
Last edited:
Re: NAND-X units R a load of s**te
TX put alot of money and testing behind their kits in fairness now if u were to say it was a MAX kit then that makes sense lol
coz 99% of the time it is
TX put alot of money and testing behind their kits in fairness now if u were to say it was a MAX kit then that makes sense lol
Re: NAND-X units R a load of s**te
i unplugged the wires going to nand-x booted up xbox got my cpu key created a freeboot nand then when i tried to flash freeboot nand back to box i started getting "cant find usb interface" like so many others that i've read about.
where about are u pm details
u have not listened to me have u when i first had ago on a xenon board it read my nand twice & even let me write xell to my nand for me to get my cpu key.
i unplugged the wires going to nand-x booted up xbox got my cpu key created a freeboot nand then when i tried to flash freeboot nand back to box i started getting "cant find usb interface" like so many others that i've read about.
where about are u pm details
krypt1c
VIP Member
Re: NAND-X units R a load of s**te
I had this today , running w7 64bit , i found i needed to reboot the pc and then it was back to a working state , i don`t think it`s the nandx though.
I had this today , running w7 64bit , i found i needed to reboot the pc and then it was back to a working state , i don`t think it`s the nandx though.