Nand X Update using CK3 Pro Rev. D Failed to Autobaud

MartosTech

Full Member
Feb 15, 2018
38
0
Hi all, so just got a CK3 Pro Rev. D and it says Failed to Autobaud while trying to update my nand x to v3 code. What do i do? Got everything set right. Seen some youtuber had soldered a wire on his but dont know if thats what i have to do. thanks
 

Raiikoh

Noob Account
Oct 4, 2019
1
1
Canada
Hi all, so just got a CK3 Pro Rev. D and it says Failed to Autobaud while trying to update my nand x to v3 code. What do i do? Got everything set right. Seen some youtuber had soldered a wire on his but dont know if thats what i have to do. thanks
Did you get this working? CK3 Pro (REV D) requires pin 1 of the pl2303 chip to be connected to pin 2 (RX) of the DVD drive connector on the back of the board - simple 1 wire connection.