JTAG NandPro v3 on win7 x64 Problems

[MOCAMBO]

Does anyone have the NandPro fully working on there win 7 x64 machine? I'm googling frantically and tried updating the dlportio.dll into the nandpro folder, but I still get errors when trying to install the port95nt file.

So I have tried adding the dll and I have tried running both files in Win xp Pro compatibility mode and I'm still getting the "Unsuppported 16 bit application" error followed by "Unable to Execute"

 

[tonyg243]

I haven't got my coolrunner etc, to perform the RGH yet,but in ubers tut to update the nandx,it says that you have to open the arm v3 hex in flash magic.The hex is in the nandpro 3 folder.I dont think you actually have to run the port95nt app within nandpro 3. I have to admit I tried to install nandpro 3 on my windows 7 64bit,after reading your post,but it wouldn't, no matter what I tried.However I was able to run Flash Magic and place the arm v3 hex from the nandpro folder into flash magic,just for test purposes. So I have no doubt that if my nandx was connected as per the instructions in the tut I would be able to update it.If I am wrong please feel free to correct me(Without facepalms please):smile:

 

[MANUMAN]

why are you trying to install the port95nt file. you dont need it i am using win 7 64 bit and i did not go near that file. i finally just programmed my cr with nand pro 3 and dump my nand 3 times with nand pro 3. gonna leave the rest until tomorrow. have all the wiring done also so hopefully i get it all up and running tomorrow

 

[cypher21]

put this one in the folder, and try again

 

[Ubergeek]

and make sure you have the x64 win 7 signed drivers for nandx installed - NOT the ones that come with nandpro3

 

[hydrasworld]

that DLPortIO fixed it for me, thanks

 

[rob753420]

i try to install that dlportiq.dll in my nand pro3 folder and the window opens and closes right away

 

[Mickey3177]

You need to use a DOS Prompt to run Nandpro, I've ran this win7 64 bit and it's a go

 

[rob753420]

thanks will try that