Hi guys, I bought a job lot of 360s and after ploughing through this site have managed to fix the majority so thanks.
My prob is this I have jtagged 4 units from the batch with no issues but the last box is driving me insane! I did the usual and soldered up the nand x cont act points ready the nand 3 times with no probs checked images etc and wrote over xell turns out one of the diodes was crappy was wouldnt boot so simply flashed back the original soz I could have a gameing session which also worked fine.
WentTo rewrite today....no flashcontroller message re soldered all the points same again soldered to underneath still nothing then used the qsb connections on other jtag and a fresh install on another machine......same message.
All Lights power up pc recognises nandx re installed drivers and used different pc.....same message.
IseIt possible I killed it somehow? Brigged connections attempting to connect leads to nand x upside down etc
AllSolder points were clean as a whistle and two installs were previously working.
OhAnd quick one on dvd drives with power cable upside down blow outs fixable by changing pcb I have 360s sammys where the notes say this has been done....I dont need the dvd keys ass they are for future replacements
Thanks
My prob is this I have jtagged 4 units from the batch with no issues but the last box is driving me insane! I did the usual and soldered up the nand x cont act points ready the nand 3 times with no probs checked images etc and wrote over xell turns out one of the diodes was crappy was wouldnt boot so simply flashed back the original soz I could have a gameing session which also worked fine.
WentTo rewrite today....no flashcontroller message re soldered all the points same again soldered to underneath still nothing then used the qsb connections on other jtag and a fresh install on another machine......same message.
All Lights power up pc recognises nandx re installed drivers and used different pc.....same message.
IseIt possible I killed it somehow? Brigged connections attempting to connect leads to nand x upside down etc
AllSolder points were clean as a whistle and two installs were previously working.
OhAnd quick one on dvd drives with power cable upside down blow outs fixable by changing pcb I have 360s sammys where the notes say this has been done....I dont need the dvd keys ass they are for future replacements
Thanks