ANSWERED NANDx stopped working after write

H

hampsterlamp

Full Member
Dec 25, 2011
70
8
ok so im using coolrunner nandxi tried to boot xell but got an error so i used nandpro to write original nand back wrote it back fine then went to check it and it says Looking for usb interface device Can not continue i looked threw the forums but could only find its bad solder which its not...reason 1 because i never touched it and there wasnt an earthquake so it never moved 2.becasue i know its not the solder
PSU is orange and it, wont boot no lights PSU stays orange with eject and power button. any help is welcome.
 
L

Looch

Noob Account
Dec 23, 2011
6
0
im guessing you messed up around the hana point, you have to replace the resistor next to it
 
Krafter

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
Are you saying that it wont even power on? No green light on the Xbox? If that is the case, it sounds like damage to the STBY_CLK near the HANA. If you do get it to power on then what happens when you disconnect the Nand-x from the Xbox and try and run nandpro? Does it find the USB device?
 
  • Like
Reactions: hampsterlamp
H

hampsterlamp

Full Member
Dec 25, 2011
70
8
sorry im distracted now i tried to reinstall drivers so i uninstalled and now its not letting me reinstall its giving me a windoes can not find driver even though its there
 
Krafter

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
That sounds right for not having the drivers installed. I'm not sure what to tell you at this point. Did you try and install it on another machine?
 
  • Like
Reactions: hampsterlamp
H

hampsterlamp

Full Member
Dec 25, 2011
70
8
no i only have one machine

---------- Post added at 20:05 ---------- Previous post was at 20:01 ----------

ok back on track drivers installed same problems
 
H

hampsterlamp

Full Member
Dec 25, 2011
70
8
i got drivers on now but they still getting same error my solder on the
POST_OUT 1 is shotty could that effect it?

---------- Post added at 20:15 ---------- Previous post was at 20:09 ----------

alright i love you, i slightly moved the STBY_CLK wire and it fell off resoldered and it worked!
 
Krafter

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
glad to hear you got it figured out. You need to apply some tape or hot glue to keep the wires from moving around but truth be told, it shouldn't fall off like that if it had a good connection to begin with.

alright i love you,
Click to expand...
And sorry to disappoint you but I am a married man. :p
 
You must log in or register to reply here.