RGH NANDx v3 can not read my NAND

[Statecowboy]

That is for glitching, so you will want to set it to Slim in your case. It wouldnt cause the issue that you've described though. As for the timing file, you should select the timing file for Trinity. It should be a pop up option in JRunner when you select to flash the coolrunner.

 

[myst77]

hmmm

when i try to flash again the CR
i press FlashCoolrunner and the options for XVSF choice are :

A
B
C
D
Falcon

no Trinity? what's about that?


edit:
i choosed RGH1 and then trinity.
flashed ok but black screen, only red light on CR. no power led on XBOX , no fan spin again

 

[Martin C]

There's obviously a hardware/solder issue which can't be seen.

Best advice here is to give it to someone else to do, whilst it's still working.

 

[myst77]

i didn't change any settings on CR3 Lite board (solder, switches), i left everything at default settings.

Is there a possibility that this causes not booting at all to XELL or i have to find other solutions?
thanks!

 

[myst77]

hey guys
i flashed the original nand

Now i connected back DVDROM, the QSB and coolrunner are still on mainboard (CR is set to PRG) and i boot.
I have no signal on TV and after some seconds the power led on console turns RED constantly

Any idea? do i have to desolder QSB and CR and try again?

 

[Martin C]

I would remove everything and pray you've not damaged it.

 

[myst77]

here again

i removed everything (and flashed before with original NAND)

Same problem...
I have no signal on TV and after some seconds the power led on console turns RED constantly

 

[Duhasst0]

Secondary error code?

 

[myst77]

how can i see that?

 

[Duhasst0]

When you get the red dot hold the sync button and press the eject button 4 times and each time you do count the number of the lights flashing ie 4 lights around the rol is 0, 1 is 1 and so on.

 

[oO Elite Oo]

i suggest you do wiring install instead if QSB are not working for you.

 

[myst77]

i get 0022

and found that:

"0022 - CPU error, generally caused by a poor connection to the mainboard (cold solder joints/bridged solder joints). This can also be triggered by an error with the TSOP."

---------- Post added at 04:33 ---------- Previous post was at 04:32 ----------

i suggest you do wiring install instead if QSB are not working for you.

yes next time for sure. personally it is easier

the problem is what to do with that console

 

[Statecowboy]

You've flashed back the original nand and you are still RROD? In that case, as mentioned you may want to get it to a pro. Chances are there's someone around you who can work on it for you.

Did you remove all of the RGH stuff before you tried to boot to stock (after you flashed your original nand back)?

 

[myst77]

Yes removed everything and had the red power light (error 0022)



Sent from my Galaxy Nexus using Tapatalk 2

 

[Statecowboy]

Hm. Is it possible when you "added solder" to some of your points you still had the console plugged in? This can cause damage to the board, such as the voltage regulators.

If I were you, I would write down everything you've done up to this point and find someone who is more knowledgable than you on the subject. No shame in that.