ANSWERED nanpro crashes when i try to program a coolrunner

[kotmfu]

So i am encountering this problem. i have a nandx with v3 software, a nandx->coolrunner cable, jtag tool and whatever else i need.

I am able to dump the nand of my 360 fine with the nandx but nandpro (which i stole from jtag tool after i realised jtag tool wasnt actually proramming the cr) but when i try to program the cr with the same nandx nandpro crashes. and when i try to do it through jtag tools advance mode it just does nothing.

i heard there was a batch of bad cr cables with 2 of the cables the wreong way around but i dont know what the proper config is so im open to any and all ideas about what this could be. i have 2 seperate coolrunners and both of them have the same problem so i dont think its the cr board.

Thanks yall in advance

---------- Post added at 22:55 ---------- Previous post was at 22:50 ----------

i should probably also say that my 360 still turns on when the nand is flashed back to stock and i set the cr to prg. the cr flashses greeen every4-5 seconds which im told means it could be soldered but my solder points look good to me. just though i should mention that. when iflash the cr though jtag tool basic it says it executed successfully but i dont know if tha means it actually worked or not

 

[Chris_S]

If it says that it executed successfully then that means it is programmed. The green light should be on before/while programming then after it has been programmed it goes off. Also you shouldn't need to use Advance mode in jtag tool. Just choose rgh -> MOBO type then on the next screen it says flash glitch board.

 

[kotmfu]

If it says that it executed successfully then that means it is programmed. The green light should be on before/while programming then after it has been programmed it goes off. Also you shouldn't need to use Advance mode in jtag tool. Just choose rgh -> MOBO type then on the next screen it says flash glitch board.

as i very poorly stated in my post i did go through jtag tool basic and it didnt work but when i was looking through help online it was suggested to use nand pro which crashes and i tried advance which does nothing and my boards green light doesnt come on it does squat when i "program" it

 

[kotmfu]

well i fugred out that problem.im not going to admit to it because it was STUPIDDDDDDDD. lol
anywho
can anyone help me with the whole not booting thing? i left it for 90 seconds with nothing just the coolrunner flashing and i believe my soldering is good

 

[Chris_S]

as i very poorly stated in my post i did go through jtag tool basic and it didnt work but when i was looking through help online it was suggested to use nand pro which crashes and i tried advance which does nothing and my boards green light doesnt come on it does squat when i "program" it

Sorry guess I missed that part of it.

well i fugred out that problem.im not going to admit to it because it was STUPIDDDDDDDD. lol
anywho
can anyone help me with the whole not booting thing? i left it for 90 seconds with nothing just the coolrunner flashing and i believe my soldering is good

What MOBO? And is the Coolrunner a ver. B?

 

[kotmfu]

its a jasper 16 and its a rev a from what i can see (no bridge for the cap)

 

[J2G]

buddy are you confused because your confusing others your title says you have one problem which you say you sorted because your stupid ! your words not mine.
Now you are talking about another problem so i tell you what im marking this thread as fixed yes then you open another thread if your problem is different to the last thread also you did not read the Sticky Pics thread by Martin C if you did you would have pictures sorted so get your sh*t together man..