Need a Good Tut for solderless 2.6 ce

[K-oss]

I've recently recieved my modchip, which is the 2.6 CE, but I also ordered the xenium solderless adapter for version 1.1 . And now I'm stuck. I know this site has a great tutorial, but its not for the Solderless adapter. I will have to desolder a little, but I would like to know what parts go where and what pieces connect. Any Ideas? And remember to use little words.

K-oss

 

[Fantmx]

Why would you have to desolder anything? The solder in the LPC bus does not need to be removed. This is an excuter support forum, not a xenuim support forum. Why not just buy the best? At any rate it can't go on much differently than the xecuter adaptor. http://team-xecuter.com/xapter/

 

[K-oss]

Well, from what I've seen, the older versions of Xbox need to desolder the pin header holes. But I'm gonna have to take another look at my mobo. I may not need to after all.

 

[Fantmx]

You don't have to remove the solder. Anyone that says that doesn't know what they are talking about. Just take a stiff pencil eraser and clean contact points up and you will be fine.