I am trying to build a stock trinity nand. I have the RGH nand but dont have the stock one anymore. I have built the stock trinity 13604 image but need the stock SMC file. Can someone please send me a stock trinity image or extract the SMC file using nandpro (nandpro xell.bin: -r16 smc.bin 0 1) Thanks.
JTAG Need donor trinity nand or dec SMC
- Thread starter gurvir19
- Start date
heres a stock trinity nand and cpu key
http://www.megaupload.com/?d=5YEV32JG
Hope it helps :biggrin:
http://www.megaupload.com/?d=5YEV32JG
Hope it helps :biggrin:
i'm in sorta the same boat.
I'm using this donor trinity nand.
How did you go about rebuilding the original stock nand?
My slim was updated to 13604 before installing CR.
I accidentally overwrote my original nanddump with the nanddump that contains my ECC image. My mistake.
So now i'm trying to continue on with trying to boot into a hacked dash, but keep getting the flashing RROD, and no image from HDMI output.
I'm trying to build an original build so
1) I can flash to slim to see if it boots without CR.
2) Need original nand to build a glitched nand.
I've extracted the KV.bin and SMC_config.bin from my nand w/ecc, and injected into donor nand. Used 360flashtool to insert my cpukey retrieved from XeLL, then took that and ran it thru Multibuilder to build a retail nand.
Then flashed my slim nand thru XeLL (xenon.elf).
Unfortunately i cannot get it to boot in any dashboard. However, Xell I can get into.
I also checked applied my LDV value from Xell into the multibuilder options.ini file.
Any help would be appreciated!
Been working on this for days!
I'm using this donor trinity nand.
How did you go about rebuilding the original stock nand?
My slim was updated to 13604 before installing CR.
I accidentally overwrote my original nanddump with the nanddump that contains my ECC image. My mistake.
So now i'm trying to continue on with trying to boot into a hacked dash, but keep getting the flashing RROD, and no image from HDMI output.
I'm trying to build an original build so
1) I can flash to slim to see if it boots without CR.
2) Need original nand to build a glitched nand.
I've extracted the KV.bin and SMC_config.bin from my nand w/ecc, and injected into donor nand. Used 360flashtool to insert my cpukey retrieved from XeLL, then took that and ran it thru Multibuilder to build a retail nand.
Then flashed my slim nand thru XeLL (xenon.elf).
Unfortunately i cannot get it to boot in any dashboard. However, Xell I can get into.
I also checked applied my LDV value from Xell into the multibuilder options.ini file.
Any help would be appreciated!
Been working on this for days!
