NEED HELP! AFTER RGH

[prhprh]

Hello, I'm new here... So I buy xbox trinity it was damaged while nanding by some noob... I think he was trying to setup coolrunner, but something goes wrong. Now it don't have any mods on board(coolrunner) like stock one. I trying to read nand but no success "Cant find controller" (NANDPRO 30a). When turning on xbox without dvd drive no sound no video and midle led flashing all the time. When dvd is pluged green light in the middle glow all the time, but still no sound/video (By the way dvd drive is from other trinity console). Its synchronising with controller. I can't get ERROR code because when I press sync button and press eject light are blinking like usual on sync. I try'd to reset NAND chip by shorting FT1T5 FT1T6 FT1T7 FT1T8, but still can't read nand.
NO DVD: [video=youtube;rpdJmRAllyE]http://www.youtube.com/watch?v=rpdJmRAllyE&feature[/video]
http://www.youtube.com/watch?v=rpdJmRAllyE&feature

WITH DVD: [video=youtube;HLVwQLcUiO8]http://www.youtube.com/watch?v=HLVwQLcUiO8&feature[/video]
http://www.youtube.com/watch?v=HLVwQLcUiO8&feature

On the bottom MOBO (under cgpu) about 9 resistors was missing. I soldered them from donor mobo, so should be OK.

One side of pads is same pin???

What is wrong with it??? Anybody can help??? THANX!!!

 

[BL4K3Y]

What are you using to read/write to the NAND?

If you aren't getting an error code, I would say that the previous owner wrote an ECC image to the console's NAND (the console will "reset" indefinitely with an ECC image written).

Do any of the RGH points appear to have been soldered to?

This is the reason why it helps to know the history of a console before buying, especially if you are buying a faulty console.

 

[prhprh]

I'm using LPT ( it reade's and write's phat consoles normally). Yes points for RGH was soldered. He removed RGH device (maybe coolrunner). If previous owner wrote ECC why I can't read nand ??? If it will help I'll buy Nand-x, but there is guarantee that nand-x will read nand? Or xbox is totally screwed?

 

[Martin C]

This is a TX product support forum. It's also worthwhile remembering that buying faulty consoles is a risky business. You don't always win.

 

[prhprh]

It's possible to test somehow the nand chip? To be sure that he isn't burned?

What I should do if ECC was writen, how I should read the nand in this case ?

 

[Martin C]

I have a feeling you ignored my reply.

I'll close the thread. Good luck on fixing your console.