Need help flashing back retail nand

[daman10]

I got the console already RGH so have no original dumps, i have a pic of xell and a nand dump from glitched image. I have tried following many other threads but keep getting red dot. Can anyone help me out how to flash back to retail please.

Its a corona motherboard V1 i believe

 

[daman10]

yea my LDV is 5 i looked at martins LDV sticky

 

[BL4K3Y]

my LDV is 5 i looked at martins LDV sticky

Use that LDV and the CB version you obtained from fuse line 2 to build a new retail image.

This thread explains what to look for and how to work it out.

 

[daman10]

Im using that thread but im confussed between step 5 & 8 because step 5 i then hav a SMC.bin but in step 8 that would replace the SMC.bin

 

[BL4K3Y]

Im using that thread but im confussed between step 5 & 8 because step 5 i then hav a SMC.bin but in step 8 that would replace the SMC.bin

Replace SMC.bin with a clean one from the pack (rename boardtype.bin to SMC.bin).

You can put your glitch image in the XeBuild\Data folder and supply SMC.bin (XeBuild will use the KV and Config blocks from the image, but it will use SMC.bin instead of the SMC it finds in the NAND image).

 

[daman10]

im still getting red light iv extracted and renamed moved to the data folder, created image without nand etc

 

[BL4K3Y]

Build a 16547 retail image with an LDV of 5.

 

[daman10]

I have managed to obtain the original NAND from the guy that did the RGH when i flash back im getting 0032 error

 

[Martin C]

I have managed to obtain the original NAND from the guy that did the RGH when i flash back im getting 0032 error

Does your original NAND match the fuses in XeLL? Read my LDV sticky for help.

 

[BL4K3Y]

I have managed to obtain the original NAND from the guy that did the RGH when i flash back im getting 0032 error

That is usually an issue with CPU_RST.

Post photos of the board please.

 

[daman10]

http://s27.postimg.org/u4f9u9o2r/image.jpg

im waiting on a new multimeter coming thru the post but i dont think thats the problem as the console glitched every now and agin

http://s15.postimg.org/iqmyndnfv/Picture.png

 

[daman10]

The point looks ok to me but i cant fully test till my new multimeter comes, when i had the CR wired in it did occasionally boot to the dash, if i write back the glitch image no red dot.

 

[daman10]

sorry been a few week since my last post iv checked the continuity ant the point isnt damaged does anyone have any suggestions where to check next please

 

[daman10]

anyone got any ideas b4 i bin it?

 

[Martin C]

Sell it for spares. Plenty of people here will be able to fix it in a jiffy.

 

[daman10]

Sell it for spares. Plenty of people here will be able to fix it in a jiffy.

how tho if its worth my while fixing ill do it, so if there is plenty of people on here who will be able tofix it then what is the fix?