GENERAL need help with glitch led for rf board

[appokruznz1028]

was wondering if i could get some help with being able to see the coolrunner chip green light glitching when i close the slim case , so was wondering what i need to do to make the 3rd person led on the rf board on a slim light up when the green light blinks on the cool runner rev c and rev b chip , maybe a picture of the install or a diagram would be cool . is there a solder point also for the led mod for the rf board off of the demon ???

 

[mm53668]

Make it simple take wire from before the resistor before the debug led and attach to positve of a new led. Then scratch a groung on the rf and attach the led

 

[TheGlow]

I was thinking about something similar. Or perhaps have the right LED on the Demons ext module blink for the CR cycles.
But 3rd or 4th player led sounds good too. That blue can be pretty bright at night.

 

[appokruznz1028]

midwest that doesnt make any sense , do you have a diagram or pics of the install to make it easier for me and others !! so something please

 

[mm53668]

I haven't installed a demon so don't know if that effects anything but this thread covers just about all options
http://www.team-xecuter.com/forums/showthread.php?t=84252&highlight=Coolrunner+Debug+mod

 

[appokruznz1028]

thanks midwest that makes way more sense , hey where in the midwest are u ?? im i wisconsin

 

[xXBlaZeXx]

Make it simple take wire from before the resistor before the debug led and attach to positve of a new led. Then scratch a groung on the rf and attach the led

good idea this:biggrin:

 

[XL3THAL VIP3RX]

i did this mod,but using a didode.looks good when you got a blue and a red led in each quadrant on the slim RF:wink: