need help

[jjee]

I recently installed the solderless x2.6 ce chip, flashed successfully but did not change it to bank 2 and instead flashed bank 1, now the xbox restarts 2 or 3 times then it frags. do I need the programmer to fix this? it boots fine to MS dash with the chip off..what do I need to do? thanx for the input.

 

[nartac]

you haven't given us enough info to help you at all. First what xbox version you got. What bios version you used. Did you make a 512k bios or just used the 256k bios. Do you still have flashbios in bank 2? etc.

 

[jjee]

sorry...I have the 1.1 version, bios used was 3029.bin file which is 1mb...on either bank, I encounter same issue.

 

[MKChampion]

the 3029 bios is for the X3 and the X3 only...an X3 bios will not work on an X2 chip (which is what you have)...you should have flashed a X2 4983 512k bios, unfortunately now that you've messed with both banks you will need a programmer or to do a hotswap

 

[nartac]

like MKChampion said. X3 bios is for X3 chips only. You should have used X2 4983 bios instead for your v1.1. Your best bet now is to use a programmer or if you have another modded xbox try hotswap the chips and install correct bios onto the chip.

edit: it would not matter if you have a programmer but if you don't and plan to reflash, I suggest to place flashbios in banks 1+2 and then X2 4983 in banks 3+4. This way, you will be able to reflash in the future if you need to. But like I said, if you have a programmer, it does not matter since you can always reprogram the chip with new bios or what not.

 

[jjee]

thank you all for the help. very appreciated!!

 

[heaay]

Hi,

I'm a little new, but can you explain a little more detials on Hot Swap? Does it require BOTH Xbox's to be the same version?

Thank You

 

[MKChampion]

all the info you need is at xbox-scene in the tutorial section