need lots of help

[bobness]

i bought a premodded x3 box and it has biosflash 3.0.0 on it i have been looking through the support and have tried everythign but nothing is helping me...my problem is that when i try flashing it through http it says unknown flash halting...it used to go through the flash process and shut down but after i turn it on it frags..so i need lots of help because i payed over 400 for this and i cant even use it yet

 

[Xecuter]

maybe read a manual ?

www.teamxecuter.com/flashbios/

 

[bobness]

ok i will say it againi if you didnt get it last time....ive looked through this forum and i have tried everything and i can tget it to work!

 

[Xecuter]

if you cant follow instructions there is nothing anyone can do for you

 

[bobness]

man you need to quit being a jerk man im sorry that im not smart with all this stuff...but you are a damn support host so do some supporting...and i can follow the damn things it just doesnt work

 

[Xecuter]

im going to educate you.....

when flashbios comes on your tv screen it says

For Help Visit Team Xecuter (http://www.teamxecuter.com/flashbios/)

if you goto that page it gives you a link to how to Flash via HTTP

http://www.teamxecuter.com/flashbios/http.htm

about half way down you will see this picture

underneath it says

This is what happens if your X3 has its flash protection enabled. You wont
be able to update anything at this stage. You need to make sure the flash
protection is set to off on the mod and on the switch if you have it connected.
You will need to start over from the beginning.

now am I an a**h**e for giving you the correct answer in the first place or are you lazy for not actually reading ?

 

[bobness]

well once again i read that one...wierd thing is that the chiped flashed the first few times but didnt work and now it says flash unknown halting...hmm how can this be when i didnt change anything

 

[Xecuter]

have you checked your switches ?

 

[bobness]

well when i flash i should use the first bank which is on on off off off right?

 

[Xecuter]

im talking about flash protection - the install manual tells you how to unprotect the mod

 

[bobness]

yes theres a flash protection on the chip right? and then on the outside theres the switches which the last switch is the flash prtection right? so it should be off and it is

 

[bonzo4]

NandPro20d, Port95nt installation help!

hey all, ive been trying to install the Port95nt.exe file that comes with NandPro20d many many times with no avail. im running windows vista 32 bit and it keeps giving me the following error:


"16 bit Windows Subsystem

C\Windows\System32\CONFIG.NT. Error Code 0x0. You do not have sufficient privilige to access this file. See your system administrator. Choose 'Close' to terminate the application."

Ive tried running this file as an administrator and changing all the permissions, but still no joy. if anyone could help me that would be GREATLY appreciated!!!