RGH Need someone near Southampton UK for STBY_CLK repair

Utmad

Utmad

VIP Member
Aug 15, 2010
3,304
118
Southampton, UK
I managed to solder all the points nicely until all went wrong with the STBY_CLK point. Screwed up the pad but not as bad as I have seen others, the resistor is still intact. Just wandering if there were any experts at soldering to repair this as I do not think my eyes are up to it anymore.

So anyone in the Hampshire region please pm me.

Thanks :facepalm:
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
If you don't find someone local and willing to post then I can help.
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Stoke on Trent, Staffordshire. I'm also up Nottingham every weekend.
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Yeah Wednesday is fine. I'm in most of the day, just let me know when you're heading down here. I'll PM you address & contact number.
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Ideally if I do the repair I might as well do the whole job just to make sure that it's working. I'm guessing it's a Phat one. I'm not bothered what ever you feel that is fair enough for the job.
 
Utmad

Utmad

VIP Member
Aug 15, 2010
3,304
118
Southampton, UK
nice one, at the moment the coolrunner is programmed no problems. I have good nandumps as I already had the nandx qsb's in place. The only thing I wanted to do before glitching was to create a clean retail nand with multi builder and keep if I ever wanted to flash to standard. Due to it being flagged offline a while ago and then follwoing some advice on how to unflag it the secdata became invalid. Xbox works no problem but could not update past 13146 as got E81 error so wanted to get nice clean 13604 nand prior to glitching as it is not banned as it has not been online since before it was flagged.
 
Last edited:
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Well it's up to you, I can just solder the wires to the trace's and alternate points since you probably have done most of the work :)
 
You must log in or register to reply here.