RGH Network Port not working

[tul18]

hi, is it possible that after i RGH my network port stoped working?
i ask this because i bought a Falcon board and didnt checked the network before RGH, so i have no clue about is condition before.
RGH working great, network is the only issue.
Had a bad block in my nandflash, but was after 050 so ignore it.

 

[BoSsLoBbYz]

You can try to remap the bad block and see if helps. And if that does not work right the original desolder the coolrunner test the network adapter if it works then it is a problem with the image if not you have a bad adapter

 

[Krafter]

Might be an issue with your dash launch install.

 

[tul18]

it does not even light the port int he router/switch.
cables are fine, tested more than 1 and they all work in others xbox falcon.

 

[cfull1]

Yeah I would go back to stock and see if it works. Eliminate all the RGH variables

 

[itchyf1ngaz]

go to system settings and then to network settings. then go to restore to factory default. then restart the xbox 360

 

[KhaineGB]

You probably have a dead network port. I found a Falcon with the exact same issue.

The console should assign itself an internal IP addy if you go to system settings. Does it do that?

 

[tul18]

he doesnt light up the switch/router port where its connect.
and in the system when i try to configure wired network the xbox says i must connect a cable, so the cable isnt detected.
my question is that if the RGH was able to do this or i likely most have a dead network port before and after.

 

[Hackerjac]

why don't you just flash back your org nand and see if the port then works ?

 

[tul18]

Do i need to remove the coolrunner flashing back to stock?

 

[Hackerjac]

no

 

[tul18]

can some1 tell me the steps to put the retail nand, can i use xell? and after that do i need to put the nand-x to read again?

 

[Martin C]

you can rename the original NAND to nandflash.bin and it will be picked up with rawflash.

If you do this, you'll need to reflash anything else via NAND-x.

 

[tul18]

you can rename the original NAND to nandflash.bin and it will be picked up with rawflash.

If you do this, you'll need to reflash anything else via NAND-x.

thanx, but do you think theres a possibility the bad block to give the error?
shall i remove the coolruner soldering or let it be while in original nand?
im asking this because all my rgh went smoothly, now this.
shall i remap the original bad block since the original one was giving the error?
sorry about the noobish

 

[Martin C]

Don't remap anything. Nobody should be messing with the original NAND dump - ever.