Networking woes!

S

sarsipias

Junior Member
Jan 3, 2005
10
0
california
Okay, since no one responded to my last post, i'll try again, only this time with more details and more precise questions.

Xbox version 1.6
Xecuter 3 mod chip installed and working
Flashed the bios with the appropriate X3 bios for v1.6 with a DVD-R
Xbox booted to the bios successfully--Xecuter ROX MY BOX--
Made no changes to the X3 bios setup
Edited the evox.ini file for a crossover cable connection as per stickie:

[Network]
SetupNetwork = Yes
StaticIP = No
Ip = 192.168.100.10
Subnetmask = 255.255.255.0
Defaultgateway = 192.168.100.1
DNS1 = 0.0.0.0
DNS2 = 0.0.0.0

Created the Evolution-X dashboard boot disk with a DVD-R
Booted and loaded the Evox dashboard
Connected the crossover cable to my PC's NIC
I set my computer IP to 192.168.100.9, and defaultgateway to 192.168.100.1

Here is where I got stuck: FlashFXP won't connect. I tried anonymous user, tried xbox for user and xbox for password, tried X3 for user and X3 for password and still no luck. (Do i need to change the password in Evox.ini to the X3 Bios default password: X3??)

When i go to System Utils>Settings in the Evox menu, no IP appears in the upper part(blue section) of the display. Like:

Type
IP 0.0.0.0
Line Status 100/Full Duplex

On my computer side the network connection is working. I'm even getting flashing on the NIC light.

Do I need to make any adjustments to my IP configuration, or to the X3 bios?

Any help would be greatly appreciated.
 
ThaCrip

ThaCrip

VIP Member
Aug 18, 2004
756
0
USA
well it depends on what your using but if u try both X3 bios to connect through ftp or evox to ftp into the xbox... make SURE DHCP is DISABLED.

i can already see based on the info u provided above that DHCP is still enabled since where it says "StaticIP = No" .... u want this to YES.

other than this it looks like u did everything perfect from looking at the info u provided ;)

the default password for the x3 config live bios, if your using it's ftp is "x3" for username/password.

the default password for evox is "xbox" for username/password.

good luck ;)
 
S

sarsipias

Junior Member
Jan 3, 2005
10
0
california
Stickie Wrong and Evolution-X to copy HD info

In the stickie by Xecuter it says to set StaticIP=No if using a crossover cable. So I am really confused now. Maybe someone needs to fix this in the Stickie ?

http://www.teamxecuter.com/forums/s...light=make+xiso

Also, can I use either the X3 bios or the Evolution-x dashboard to copy HD to the PC? I was under the impression that you had to do this via Evolution-x dashboard.
 
F

Floppy Mohawk

VIP Member
Jan 5, 2004
1,499
0
Deltona, Florida
sarsipias said:
nevermind, figured it out, now it all makes sense. These forums are not clear at all.
Click to expand...
You gotta be kidding.
 
You must log in or register to reply here.