GENERAL New 360S Console - want Demon + Slim Proto V2 ?

[culdaraul]

I think I wouldn't buy the programmer as the only console I mood is mine.
I am taking into consideration a fan mod, because the temperature in our room is usually around 24-25 degreees Celsius and a big fan speed would help a lot. What do you guys think?

I've seen on several youtube videos that demon usually connects to coolruner through the white flex cable, but I haven't seen how it connects to slim proto. Please help me to figure this situation .

Thank you for support. Tomorrow I will order the parts :-D.

 

[xzanox]

The slim proto V2 has an CR_EN solder pad on it that you wire connect with the demon: read this again http://team-xecuter.com/forums/showthread.php?t=139308

Btw you can regulate your temps/fan speed within dashlaunch once rgh'd.

 

[culdaraul]

Hello, again.

After a long time, I got the parts for my mod setup. I have installed both the Demon and Slim Proto v2 using the details on forum (even the post-fix adaptor and the CR_EN cable between demon and slim proto). I think i have Corona V3 board (the console has 250gb hdd).

By now, I tested the nand on demon by flashing the original image which was read using demon and it booted fine, but now I'm stuck on what to do next. As described in J Runner pdf, i had to read the flash, create ecc, write back ecc and then start xell, but this isn't happening. I think I am in one of two situations:
1. The steps are correct, but slim proto cannot glitch (debug led flashes quickly, at an interval of 5-6 seconds), maybe I shoult try new combinations.
2. The steps i followed in Jrunner are not correct and here I need your help. Can you describe exactly what I have to do in J Runner, in order to do it the right way?

Thank you for your patience. I will post soon some pictures with my work.

 

[culdaraul]

Hello, again.
It looks like the mistake is that i didn't bridge RC27 and RC26 resistors and in consequence the i2c signal goes nowhere.
Is there anything left to be done, or it has to glitch now?

I will try later on to see if it's working, after i get back from work.

 

[cocoqui]

I'm looking to do this setup too with a brand new console. I only had experience with a Phat that I jtaged. So I'm following this thread closely.

 

[culdaraul]

For me, it works like a charm. Got almost instant boot with 1 glitch with 2 minutes tuning .

Now I'm installing few games and see how it works.