New Corona V4 Success

[BigWolf]

is i said in my previous post, start your own thread.
the oscillator (what you call crystal) is fine (green led is flashing) and the video does not prove anything since you arent measuring the signal on its output!

im sure it should measure 48.000000hz +- 5 or 10 ppm.

I may have found my answer in this thread: http://team-xecuter.com/forums/showthread.php?t=97109
I did not know I could not flash the DGX, and I just tried to program it with the Nand-X in one of my attempts at using the jed 4-3 JRunner

 

[Antalpromille]

I may have found my answer in this thread: http://team-xecuter.com/forums/showthread.php?t=97109
I did not know I could not flash the DGX, and I just tried to program it with the Nand-X in one of my attempts at using the jed 4-3 JRunner

And if you would have done what you should have done, starting a thread based on the template and with logs and pictures, this would have been solved in a few minutes.

And as i said, the oscillator is fine, but you didnt listen.
Go buy yourself a new DGX, and follow the tutorials.

 

[BigWolf]

And if you would have done what you should have done, starting a thread based on the template and with logs and pictures, this would have been solved in a few minutes.

And as i said, the oscillator is fine, but you didnt listen.
Go buy yourself a new DGX, and follow the tutorials.

Yeah, and this solution is, buy a new DGX? it can not be reprogrammed?

 

[jsinger47]

Yeah, and this solution is, buy a new DGX? it can not be reprogrammed?

That is correct. There will be no xsvf released to the public for dgx.

In the case of a spelling error, I blame Tapatalk.

 

[BigWolf]

That is correct. There will be no xsvf released to the public for dgx.

In the case of a spelling error, I blame Tapatalk.

I can send the DGX for TX to be reprogrammed?

 

[Antalpromille]

I can send the DGX for TX to be reprogrammed?

Probably not. If you just would have read the tutorials from the start.

 

[BigWolf]

Probably not. If you just would have read the tutorials from the start.

Thanks, thanks to all

 

[BigWolf]

Well guys, I solved the problem with the DGX, which actually only today after dozens of tentavivas, I discovered that the problem was R2C6 and R2C7 in resistors, which was resolved only doing a jamper solder the resistors, and so could do DGX work and extract my CPU Key
Thanks for DGX TX. :rolleyes2:

 

[nishat]

Thanx bro for ur beautiful post it helps me a lot to finish my ver 4 rgh method

 

[WNYConsoles]

OP - What was your RST length on the DGX install?

 

[tr4ckerz]

I used standard wire for CPU_RST that came with DGX, soldered on C5R11 under Xclamp (tried also alternative FT3T10, but I could not get Xell with that setup).