new nand for zehpyr?

[hacktheworld]

so this is my first cr install.
i used the qsb's. (got v1 of the qsb in the nand x connect kit, so i did the alternate clk point on bottom of mb.)
I programmed the cr with jtag tool.
I read nand twice and compared, with jtag tool, all was good.
I wrote ecc. and flashed.
I go to boot into xell with the eject and i get nothing on the tv screen.
I made sure i was switched to phat and nor before the boot.
i searched this forum and google and youtube, and found i should use multi builder to make ecc.
I did and flashed it to my xbox with jtag, still nothin on screen, cr is flashin every 5 sec but no rol or bootup....i am lost

 

[WestCoastConsoles]

Post pics of your install. Zephyrs can be a bitch to get going. Clear high res pics.

 

[The504]

so this is my first cr install.
i used the qsb's. (got v1 of the qsb in the nand x connect kit, so i did the alternate clk point on bottom of mb.)
I programmed the cr with jtag tool.
I read nand twice and compared, with jtag tool, all was good.
I wrote ecc. and flashed.
I go to boot into xell with the eject and i get nothing on the tv screen.
I made sure i was switched to phat and nor before the boot.
i searched this forum and google and youtube, and found i should use multi builder to make ecc.
I did and flashed it to my xbox with jtag, still nothin on screen, cr is flashin every 5 sec but no rol or bootup....i am lost

Try a combo of Power on wait couple secs unplug power plug, plug back in plug try to boot.

 

[nofeloniesyet]

you probably just need to route your wires away from anything that could cause interference.you should search the forums here for best wire placement.

 

[hacktheworld]

ok will double check wire routing, but i followed the pic here on the forum,

solder is good i double and triple checked, and had no problem reading, writing or flashing nand...

"Try a combo of Power on wait couple secs unplug power plug, plug back in plug try to boot."
I will try this right now...

 

[hacktheworld]

ok...
added cap to see if it would help...no change
did the unplug thing like ten times ten different ways and no change...
green center light just flashes forever and it doesn't boot, any more suggestions?
I read something about using multi builder to make a retail flash? i made a ecc with multibuilder but i could not find a tut on anything multibuilder....someone point me to one?

 

[Martin C]

You can't make a retail NAND without your CPU key..

Can you post pics of your wiring?

 

[Disperat]

Instead of using multi_builder for retail image, I would write only the first 50 blocks from original nand by using:

nandpro.exe usb: -w16 orignand.bin 1 50

(someone correct me if I'm wrong, please)

By the way, to build a retail image in Multi_builder, you need the CPU Key, which I understand you don't have. (again, someone correct me if I'm wrong)

I think there is a bad soldering somewhere on CR wires, or placing problem of the wires.

---------- Post added at 10:48 ---------- Previous post was at 10:48 ----------

Oh. I didn's saw Martin's post. Sorry.

 

[hacktheworld]

it was a bad connection....thanks everyone!!!

 

[WNYConsoles]

Reference the following image on how your wires should look on the bottom of a Phat CoolRunner install.