New problem. CR4-Demon

[joshypoo]

So if it works fine with other Glitch methods why is it not working with this one?

I have noticed that when it was working with other glitch methods the debug light will come on for a few seconds go out and then retail will boot.

Instead it is flashing once really quick every 5 seconds. so yes the demon is not disabling the CR when booting Retail

 

[Utmad]

So if it works fine with other Glitch methods why is it not working with this one?

Maybe you just havent got it connected properly.

 

[Krafter]

I'd lay money on the fact it's because you don't have the CR_EN wired up. It won't take but two minutes to run a wire form the Demon the the CR4. Give it a try.

 

[jekdyell]

Seems you don't do what you been told to try.

Just remove the 5v wire from the cr4 and see if retail nand boots.

If it dose then remove the ribbon cable from the demon and cr4,and just solder a wire from the cr_en pad on the demon,and solder the other end to the cr_en pad on the cr4,then try and see if it boots retail.